Need a new water service pipe? You are in good hands. I am a fully qualified water mains Pipe installer with relevant water hygiene tickets. A new water service pipe increases the water volume Your boiler gets and helps to prevent pressure drops in households with multiple bathrooms especially. This is due to the internal bore between the lead pipe and the new MDPE pipe and is often recommended by the plumbers. All new water mains are to be installed in a traditional way by excavating the trenches to lay the pipe always in protective ducting, covered with sand and water mains below warning tape. The trenches are then to be backfilled and remedial works restored on a like to like basis. Why lay pipe in ducting instead of moling? Simply because when a mole is used it bores the tunnel in a soil/clay allowing for pushing new pipe between excavation pits but the pipe isn’t protected in any ways. Only installing it in a ductiong ensures it’s long lasting hence why I do not offer moling at all. I always replace the service pipe all the way to the stopcock valve in the footpath and don’t leave a section of old lead pipe that will eventually burst under the excuse that the valve was too far from the boundary. In those circumstances I arrange with Your water provider to either reinstall it or extend MDPE from the box to the boundary so I can connect MDPE to MDPE. New water supply pipes are flushed , chlorinated and water mains ground breaker box is used as a point of entry to the building .Therefore if you are planning on adding an extra bathroom or just simply want to get rid of Your old led and poisoning water supply pipe , don’t waste no time and hit the contact button for Your free fixed quote.